If you have been reading about chromatogram and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Updated 2026-01-27. Numbers and descriptions here follow the published literature rather than marketing material.
Routine quality control monitors retention time shifts, baseline noise, system pressure, and peak shape. Trends can reveal column aging, mobile phase preparation errors, detector drift, or sample degradation. Corrective actions may include replacing the column, preparing fresh mobile phase, or recalibrating the detector. Stability testing often uses HPLC to measure parent compound loss and degradation product formation. Open questions remain about how accelerated stability results extrapolate to long-term storage under varied conditions.
Quality control for HPLC testing combines scheduled checks, documented procedures, and review of results. Before sample analysis, system suitability testing confirms that the instrument, column, and method meet predefined criteria. Common criteria include resolution between critical peaks, retention time precision, peak tailing, and theoretical plate count. Failure triggers investigation before results are reported. Records link raw data, calculations, instrument logs, and analyst identity to each batch, supporting audits and repeat analysis.
Reversed-phase chromatography dominates modern HPLC testing, using a nonpolar stationary phase such as chemically bonded octadecyl groups and a polar mobile phase of water mixed with organic solvent. Analytes partition between the mobile and stationary phases according to hydrophobicity. Gradient elution changes the mobile phase composition over time to separate compounds with a wide range of retention. Isocratic elution keeps the composition constant and is simpler for routine assays. Column temperature, pH, and flow rate influence selectivity, peak shape, and retention time, so these parameters are controlled during a validated method.
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. A diode array detector records full spectra across a wavelength range, which helps identify co-eluting peaks. Mass spectrometry provides mass-to-charge ratios and can confirm molecular identity at low concentrations. The choice of detector depends on analyte structure, required sensitivity, and whether quantitation or identification is the goal. No single detector works for every compound, and method development often compares responses before selecting one.
High-performance liquid chromatography is an analytical technique that separates components of a liquid sample by passing it through a packed column under pressure. A pump delivers a mobile phase at a controlled flow rate, and an injector introduces the sample into the stream. Differences in interaction with the stationary phase cause analytes to migrate at different rates. Detectors record elution as peaks, and a data system converts signals into a chromatogram. The method is suited to compounds that dissolve in a liquid and are not volatile enough for gas chromatography.
| Property | Value | Notes |
|---|---|---|
| Retention time RSD | ≤1% for five replicate injections | Typical criterion; method-specific limits apply. |
| Resolution | ≥1.5 between critical pair | Baseline separation is generally desired. |
| Tailing factor | ≤2.0 | Measures peak symmetry. |
| Theoretical plates | ≥2000 per column | Method-dependent; higher values indicate greater efficiency. |
| Peak area RSD | ≤2% for replicate injections | Reflects autosampler and detector precision. |
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. UV detection is widely used because many organic compounds absorb light, but it requires a chromophore. Mass spectrometry provides mass-based identification and high sensitivity for trace analytes. Each detector has trade-offs in selectivity, cost, and compatibility with mobile phases. Quantification typically uses calibration curves prepared from reference standards. Results are reported as concentration, purity, or presence above a limit.
HPLC testing separates dissolved compounds by passing a liquid sample through a column packed with stationary phase. A pump delivers mobile phase at controlled flow, and the sample components interact differently with stationary and mobile phases. Compounds that spend more time in mobile phase elute earlier; those retained by stationary phase elute later. Detectors record elution as peaks, and peak area or height relates to amount. This mechanism underpins quantitative analysis of mixtures.
Instrumentation includes a solvent delivery system, an autosampler, a column oven, and one or more detectors. Reversed-phase columns with chemically modified silica are widely used, but normal-phase, ion-exchange, size-exclusion, and affinity modes exist for specific separations. Detectors may rely on ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry. Column temperature, mobile phase composition, and flow rate are adjusted to improve resolution. System pressure is monitored because rising pressure can indicate column blockage or deteriorating packing.
Separation performance depends on particle size, pore size, column length, and the chemistry of the stationary phase. Smaller particles generally improve efficiency but require higher pressure and suitable instrumentation. The mobile phase often contains buffers and organic solvents that influence retention and selectivity. Testing labs select conditions based on the analytes, sample matrix, and required sensitivity. Method development frequently involves screening several columns and solvent mixtures before a final set of conditions is chosen.
High-performance liquid chromatography testing separates components of a liquid sample by forcing a mobile phase through a packed column. The stationary phase inside the column interacts with analytes to different degrees, so each compound exits at a characteristic retention time. A pump delivers solvent at controlled flow and pressure, while an injector introduces a precise sample volume. Detectors such as ultraviolet-visible, fluorescence, refractive index, or mass spectrometric instruments record the separated bands. The resulting chromatogram provides qualitative and quantitative information about the mixture.
Separation modes differ by the chemistry of the stationary phase and the composition of the mobile phase. Reversed-phase testing uses a nonpolar column and polar solvents, making it common for pharmaceutical, environmental, and food analytes. Normal-phase testing uses a polar column and nonpolar solvents for compounds that are poorly retained in reversed-phase systems. Ion-exchange and ion-pair methods separate charged species, while size-exclusion methods sort molecules by hydrodynamic volume. Gradient elution changes solvent strength over time to resolve complex mixtures, and isocratic elution holds solvent composition constant for simpler assays.
Solid-liquid extraction based ambient ionization is based on the use of a charged spray, for example electrospray to create a liquid film on the sample surface. Molecules on the surface are extracted into the solvent. The action of the primary droplets hitting the surface produces secondary droplets that are the source of ions for the mass spectrometer. Desorption electrospray ionization (DESI) is one of the original ambient ionization sources and uses an electrospray source to create charged droplets that are directed at a solid sample. The charged droplets pick up the sample through interaction with the surface and then form highly charged ions that can be sampled into a mass spectrometer. Desorption atmospheric pressure photoionization (DAPPI) is a solid-liquid extraction ambient ionization method that enables the direct analysis of samples deposited on surfaces by means of a jet of hot solvent vapour and ultraviolet light. The hot jet thermally desorbs the sample from a surface and the vaporized sample is ionized by a vacuum ultraviolet light and consequently sampled into a mass spectrometer.
These cyclic dipeptides incorporate both donor and acceptor groups for hydrogen bonding. They are conformationally constrained nearly planar scaffolds. Diversity can be introduced at up to six positions and stereochemistry controlled at up to four positions. They are stable to proteolysis. These characteristics underpin theis biologically activity and utility in medicinal chemistry. As a consequence of their predominant biosynthetic origin from L-α-amino acids most naturally occurring 2,5-DKPs are cis configured as the cyclo(L-Xaa-L-Yaa) isomers. 2,5-DKPs epimerize under basic, acidic and thermal conditions. The composition of the cis and trans isomers in the equilibrium state varies widely depending on the bulk of the side chains, if a ring (e.g. proline) is present, or if the nitrogen atoms are alkylated . Although epimerization was historically an issue in the synthesis of 2,5-DKPs, several mild methods have been developed recently that avoid epimerization.
Adenylyl-sulfate reductase (glutathione) (EC 1.8.4.9) is an enzyme that catalyzes the chemical reaction AMP + sulfite + glutathione disulfide ⇌ {\displaystyle \rightleftharpoons } adenylyl sulfate + 2 glutathione The 3 substrates of this enzyme are adenosine monophosphate, sulfite, and glutathione disulfide, whereas its two products are adenylyl sulfate and glutathione. This enzyme belongs to the family of oxidoreductases, specifically those acting on a sulfur group of donors with a disulfide as acceptor. The systematic name of this enzyme class is AMP,sulfite:glutathione-disulfide oxidoreductase (adenosine-5'-phosphosulfate-forming). Other names in common use include 5'-adenylylsulfate reductase (also used for, internal_xref(ec_num(1,8,99,2))), AMP,sulfite:oxidized-glutathione oxidoreductase, (adenosine-5'-phosphosulfate-forming), and plant-type 5'-adenylylsulfate reductase. In plants, APS is reduced by the plastidic enzyme APS reductase (APR; EC 1.8.4.9) in the presence of physiological concentrations of reduced glutathione (GSH), which acts as an electron donor.
March 12 – 17: 2018 Youth Pan American Championships (Men) in Guadalajara In the final, Argentina defeated Mexico, 3–2. Canada took third place and Paraguay took fourth place. March 12 – 17: 2018 Youth Pan American Championships (Women) in Guadalajara In the final, Argentina defeated Uruguay, 4–0. Mexico took third place and Paraguay took fourth place. May 13 – 20: 2018 Asian Women's Hockey Champions Trophy in Donghae City South Korea defeated India, 1–0, to win their third Asian Women's Hockey Champions Trophy title. China took third place. October 18 – 28: 2018 Asian Men's Hockey Champions Trophy in Muscat Note: Due to heavy rain, both India and Pakistan took first place here. Malaysia took third place. July 11 – 15: IFA 2018 Fistball U18 World Championships in Roxbury Township July 24 – 28: IFA 2018 Fistball Women's World Championship in Linz
Sources: en.wikipedia.org
Discovered by Tillett and Francis in 1930, it was initially thought that CRP might be a pathogenic secretion since it was elevated in a variety of illnesses, including cancer. The later discovery of hepatic synthesis (made in the liver) demonstrated that it is a native protein. Initially, CRP was measured using the quellung reaction which gave a positive or a negative result. More precise methods nowadays use dynamic light scattering after reaction with CRP-specific antibodies. CRP was so named because it was first identified as a substance in the serum of patients with acute inflammation that reacted with the cell wall polysaccharide (C-polysaccharide) of pneumococcus.
{\displaystyle \langle \Psi _{nlm_{l}m_{s}}|\mu |\Psi _{n'l'm_{l}'m_{s}'}\rangle } For example in the E1 transition, unless Δ l = ± 1, Δ ml = 0 or ± 1, Δ ms = 0, and Δ n = any integer, the equation above will yield a value equal to zero and the transition would be known as a “forbidden transition”. For example, this would occur for certain cases like when Δ l = 2. In this case, the transition would not be allowed and therefore would be much weaker than an allowed transition. These specific values for the changes in quantum numbers are known as the selection rules for the allowed transitions and are shown for common transitions in the table below: Cold vapour atomic fluorescence spectroscopy Atomic spectral line Prospects in Analytical Atomic Spectrometry – tendencies in five main branches of atomic spectrometry (absorption, emission, mass, fluorescence and ionization spectrometry) Learning by Simulations – various atomic absorption and emission spectra Atomic Spectroscopy: A Compendium of Basic Ideas, Notation, Data, and Formulas
The word analgesic derives from Greek an- (ἀν-, "without"), álgos (ἄλγος, "pain"), and -ikos (-ικος, forming adjectives). Such drugs were usually known as "anodynes" before the 20th century. Analgesics are typically classified based on their mechanism of action. Paracetamol, also known as acetaminophen, is a medication used to treat pain and fever. It is typically used for mild to moderate pain. In combination with opioid pain medication, paracetamol is now used for more severe pain such as cancer pain and after surgery. It is typically used either by mouth or rectally but is also available intravenously. Effects last between two and four hours. Paracetamol is classified as a mild analgesic, and is generally safe at recommended doses. Nonsteroidal anti-inflammatory drugs (NSAIDs) are a drug class that groups together drugs that decrease pain and lower fever, and, in higher doses, decrease inflammation. The most prominent members of this group of drugs—aspirin, ibuprofen, naproxen, and diclofenac—are all available over the counter in most countries.
This is the largest division of the Society. It marked its 100th anniversary in 2008. The first Chair of the Division was Edward Curtis Franklin. The Organic Division played a part in establishing Organic Syntheses, Inc. and Organic Reactions, Inc. and it maintains close ties to both organizations. The Division's best known activities include organizing symposia (talks and poster sessions) at the biannual ACS National Meetings, for the purpose of recognizing promising Assistant Professors, talented young researchers, outstanding technical contributions from junior-level chemists, in the field of organic chemistry. The symposia also honor national award winners, including the Arthur C. Cope Award, Cope Scholar Award, James Flack Norris Award in Physical Organic Chemistry, Herbert C. Brown Award for Creative Research in Synthetic Methods. The Division helps to organize symposia at the international meeting called Pacifichem and it organizes the biennial National Organic Chemistry Symposium (NOS) which highlights recent advances in organic chemistry and hosts the Roger Adams Award address. The Division also organizes corporate sponsorships to provide fellowships for PhD students and undergraduates. It also organizes the Graduate Research Symposium and manages award and travel grant programs for undergraduates.
A typical intracellular concentration of ATP is 1–10 μmol per gram of muscle tissue in a variety of eukaryotes. The dephosphorylation of ATP and rephosphorylation of ADP and AMP occur repeatedly in the course of aerobic metabolism. ATP can be produced by a number of distinct cellular processes; the three main pathways in eukaryotes are (1) glycolysis, (2) the citric acid cycle/oxidative phosphorylation, and (3) beta-oxidation. The overall process of oxidizing glucose to carbon dioxide, the combination of pathways 1 and 2, known as cellular respiration, produces about 30 equivalents of ATP from each molecule of glucose. ATP production by a non-photosynthetic aerobic eukaryote occurs mainly in the mitochondria, which comprise nearly 25% of the volume of a typical cell.
Sources: en.wikipedia.org
System suitability is typically performed before each batch or according to the validated method and laboratory procedure. Some long runs include periodic checks during analysis. The required frequency depends on regulatory expectations and method performance.
Retention time drift can result from changes in mobile phase composition, column temperature, pump flow, or column age. A gradual shift often points to column degradation. A sudden shift may indicate a leak, mixing error, or incorrect mobile phase.
Retention time alone cannot confirm identity because different compounds may elute at similar times. Coupling HPLC with mass spectrometry or comparing against authenticated standards increases confidence. Confirmation usually requires orthogonal data.
HPLC testing separates and quantifies components in a liquid sample. It is used to check identity, purity, concentration, or stability. The technique works best for compounds that dissolve and are not easily vaporized.