A practical reference on Reversed-phase: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2025-06-25 and is reviewed periodically as new material appears.
Method validation establishes that an HPLC procedure is suitable for its intended use. Key parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Accuracy measures agreement with a true or accepted value, while precision describes repeatability and intermediate precision. Specificity confirms that the method measures the analyte without interference from impurities, degradants, or excipients. Validation is documented in a protocol and report, and acceptance criteria are set before experiments begin. Regulatory guidance varies by region, but the general principles are widely harmonized.
System suitability testing is performed before and during analytical runs to confirm that the instrument and method are working as expected. Common checks include retention time, peak area, resolution between critical pairs, tailing factor, and theoretical plate count. Results are compared with predefined limits, and a failed check requires investigation before sample results are reported. Quality control samples at low, middle, and high concentrations are injected at intervals to monitor accuracy and precision. Blank injections detect carryover and contamination, while control charts track performance over time.
HPLC testing is an analytical technique used to separate, identify, and quantify components in a liquid sample. It relies on a pressurized mobile phase that carries the sample through a column packed with stationary phase. Different compounds travel at different rates because of interactions with the stationary and mobile phases. The resulting signal versus time is a chromatogram. Peak position indicates identity under specified conditions, while peak area or height relates to amount.
Laboratories apply HPLC testing across pharmaceutical, food, environmental, and industrial chemistry. The method can measure active ingredients, impurities, additives, preservatives, and degradation products. Sample preparation often includes dilution, filtration, and sometimes extraction or derivatization. The choice of column, mobile phase, pH, temperature, and detector depends on the analytes and matrix. Results are compared with reference standards to assign identity and concentration. Method suitability is judged by resolution, precision, and accuracy.
HPLC testing is not a single fixed procedure; it is a family of separation modes. Reversed-phase, normal-phase, ion-exchange, size-exclusion, and affinity chromatography each suit different analyte properties. Reversed-phase methods dominate because they handle many neutral and moderately polar compounds. Detection can be optical, electrochemical, or mass spectrometric, and the detector dictates what information is available. Coupling with mass spectrometry increases selectivity and enables identification when standards are unavailable. The technique cannot separate every mixture without adjustment.
| Property | Value | Notes |
|---|---|---|
| Validation parameter | Accuracy | Measured value compared with true or accepted value |
| Precision type | Repeatability | Same analyst, instrument, and short time interval |
| Linearity range | 50–150% of target concentration | Common for assay methods; method-dependent |
| Limit of quantitation | Signal-to-noise ratio of 10:1 | Lowest concentration with acceptable precision |
| Common synonyms | Method validation, analytical validation | Documented confirmation that a method is suitable |
Method validation evaluates accuracy, precision, specificity, linearity, range, detection limit, quantitation limit, and robustness. Regulatory guidance for pharmaceuticals, foods, and environmental testing defines expected documentation and acceptance criteria. Verification confirms that a validated method works in a specific laboratory with its own instruments and reagents. Calibration curves use reference standards with known purity and traceability, while measurement uncertainty is estimated from validation data, control charts, and collaborative studies. The scope of validation depends on the method's intended use.
Routine quality control monitors retention time shifts, baseline noise, system pressure, and peak shape. Trends can reveal column aging, mobile phase preparation errors, detector drift, or sample degradation. Corrective actions may include replacing the column, preparing fresh mobile phase, or recalibrating the detector. Stability testing often uses HPLC to measure parent compound loss and degradation product formation. Open questions remain about how accelerated stability results extrapolate to long-term storage under varied conditions.
The American Society of Plant Biologists (ASPB) is a non-profit professional society for research and education in plant science. It was founded in 1924 as the American Society of Plant Physiologists (ASPP); the name was changed in 2001. Membership in the society is open to any person from any country who deals with physiology, molecular biology, environmental biology, cell biology and plant biophysics or related issues. It has over 4,000 members worldwide. The society publishes the peer-reviewed journals Plant Physiology (1926–) and The Plant Cell (1989–) as well as ASPB News. The American Society of Plant Biologists also has partnered with the Society for Experimental Biology, and John Wiley & Sons to publish an online-only science journal Plant Direct. In 2000, it published the first edition of the textbook Biochemistry & Molecular Biology of Plants. The first President of the Society was Charles Albert Shull (1924–1925), with founder R. B. Harvey as Secretary-Treasurer. Other presidents of the Society include Harry Beevers (1961–1962), Aubrey Naylor (1960–1961), and Katayoon Dehesh (2021-2022). The first woman to be president of the society was Elisabeth Gantt (1988–1989).
While the initial consolidation of Air Force laboratories reduced overhead and budgetary pressure, another push towards a unified laboratory structure came in the form of the National Defense Authorization Act for Fiscal Year 1996, Section 277. This section instructed the Department of Defense to produce a five-year plan for consolidation and restructuring of all defense laboratories. The currently existing laboratory structure was created in October 1997 through the consolidation of Phillips Laboratory headquartered in Albuquerque, New Mexico, Wright Laboratory in Dayton, Ohio, Rome Laboratory (formerly Rome Air Development Center) in Rome, New York, and Armstrong Laboratory in San Antonio, Texas and the Air Force Office of Scientific Research (AFOSR). The single laboratory concept was developed and championed by Maj Gen Richard Paul, who was Director of Science & Technology for AFMC and Gen Henry Viccellio Jr, and then became the first Commander of AFRL.
5-Hydroxytryptophan (5-HTP), used medically as oxitriptan, is a naturally occurring amino acid and chemical precursor as well as a metabolic intermediate in the biosynthesis of the neurotransmitter serotonin. 5-HTP can be manufactured and used as a drug and supplement with the INNTooltip International Nonproprietary Name oxitriptan. Brand names include Cincofarm, Levothym, Levotonine, Oxyfan, Telesol, Tript-OH, and Triptum. As a drug, it is used in the treatment of depression and for certain other indications. 5-HTP is produced from the amino acid tryptophan through the action of the enzyme tryptophan hydroxylase. Tryptophan hydroxylase is one of the biopterin-dependent aromatic amino acid hydroxylases. Production of 5-HTP is the rate-limiting step in 5-HT (serotonin) synthesis. 5-HTP is normally rapidly converted to 5-HT by amino acid decarboxylase.
Sources: en.wikipedia.org
Automation of synthesis has three main benefits: increased efficiency, quality (yields and purity), security, and safety, all resulting from decreased human involvement. As machines work faster than humans and are not prone to human error, throughput and reproducibility increases. Additionally, as humans spend less time in the lab exposure to dangerous chemicals is significantly decreased. This allows chemists additional time for theory and collaborative discussions. Additional benefits include: multitasking, performing tasks beyond the scope of human precision or ability, exhaustive analysis, etc.
Abraham White (March 8, 1908 – February 14, 1980) was a professor of biochemistry who made several important discoveries in his field during the middle of the 20th century and helped write a foundational textbook, Principles of Biochemistry, which was published in 1954. The book went through six editions before its authors retired. White was born in Cleveland, Ohio, to Morris and Lena White. His siblings were Essie and Julius ("Jay"). When he was about one year old, his family moved to Lafayette, Colorado, and then later to Denver. White earned his bachelor's and master's degrees at the University of Colorado and a Ph.D. degree in Physiological Chemistry at the University of Michigan in the laboratory of Howard B. Lewis. This was followed by a postdoctoral fellowship at the Yale School of Medicine with Hubert Bradford Vickery at the Connecticut Agricultural Experiment Station.
Adhesion G protein-coupled receptor G1 also known as GPR56 is a protein encoded by the ADGRG1 gene. ADGRG1 is a member of the adhesion GPCR family. Adhesion GPCRs are characterized by an extended extracellular region often possessing N-terminal protein modules that is linked to a TM7 region via a domain known as the GPCR-Autoproteolysis INducing (GAIN) domain. ADGRG1 is expressed in liver, muscle, tendon, neural, and cytotoxic lymphoid cells in human as well as in hematopoietic precursor, muscle, and developing neural cells in the mouse. ADGRG1 has been shown to have numerous role in cell guidance/adhesion as exemplified by its roles in tumour inhibition and neuron development. More recently it has been shown to be a marker for cytotoxic T cells and a subgroup of Natural killer cells. The ADGRG1 protein binds transglutaminase 2 to suppress tumor metastasis and binds collagen III to regulate cortical development and lamination.
The European Aviation Safety Agency (EASA) is tasked by Article 15(4) of Regulation (EC) No 216/2008 of the European Parliament and of the Council of February 20, 2008, to provide an annual review of aviation safety. The Annual Safety Review presents statistics on European and worldwide civil aviation safety. Statistics are grouped according to type of operation, for instance, commercial air transport, and aircraft category, such as aeroplanes, helicopters, gliders, etc. The Agency has access to accident and statistical information collected by the International Civil Aviation Organization (ICAO). States are required, according to ICAO Annex 13, on Aircraft Accident and Incident Investigation, to report to ICAO information, on accidents and serious incidents to aircraft with a maximum certificated take-off mass (MTOM) over 2250 kg. Therefore, most statistics in this review concern aircraft above this mass. In addition to the ICAO data, a request was made to the EASA Member States to obtain light aircraft accident data. Furthermore, data on the operation of aircraft for commercial air transport were obtained from both ICAO and the NLR Air Transport Safety Institute.
Sources: en.wikipedia.org
Adenomatous polyposis coli protein 2 is a protein that in humans is encoded by the APC2 gene. This is a dual-functional protein which is especially prevalant in the developing brain, and involved in cell signaling (specifically Wnt signaling) and stabilizing the cytoskeleton. Frizzled receptors are a type of cell receptor involved in a variety of functions including embryonic development and cell proliferation. These receptors trigger a cascade of reactions called the Wnt signaling pathway that eventually leads to interaction with the DNA via the protein beta-catenin, which affects which proteins get produced by the cell. The APC2 protein promotes the formation of a protein complex which is involved in breaking down the protein beta-catenin. The APC2 protein stabilizes microtubules, which are part of the cell cytoskeleton. It may also be involved in the regulation of actin fibers my means of GTPase activation (specifically the Rho family).
Modern definitions are concerned with the fundamental chemical reactions common to all acids. Most acids encountered in everyday life are aqueous solutions, or can be dissolved in water, so the Arrhenius and Brønsted–Lowry definitions are the most relevant. The Brønsted–Lowry definition is the most widely used definition; unless otherwise specified, acid–base reactions are assumed to involve the transfer of a proton (H+) from an acid to a base. Hydronium ions are acids according to all three definitions. Although alcohols and amines can be Brønsted–Lowry acids, they can also function as Lewis bases due to the lone pairs of electrons on their oxygen and nitrogen atoms.
Lipid vesicles or liposomes are approximately spherical pockets that are enclosed by a lipid bilayer. These structures are used in laboratories to study the effects of chemicals in cells by delivering these chemicals directly to the cell, as well as getting more insight into cell membrane permeability. Lipid vesicles and liposomes are formed by first suspending a lipid in an aqueous solution then agitating the mixture through sonication, resulting in a vesicle. Measuring the rate of efflux from the inside of the vesicle to the ambient solution allows researchers to better understand membrane permeability. Vesicles can be formed with molecules and ions inside the vesicle by forming the vesicle with the desired molecule or ion present in the solution. Proteins can also be embedded into the membrane through solubilizing the desired proteins in the presence of detergents and attaching them to the phospholipids in which the liposome is formed. These provide researchers with a tool to examine various membrane protein functions.
Afamelanotide is a synthetic tridecapeptide and a structural analogue of α-melanocyte stimulating hormone (α-MSH). It is a melanocortin receptor agonist and binds predominantly to the MC1 receptor. Its binding lasts longer than that of α-MSH. This results in part from afamelanotide's resistance to immediate degradation by serum or proteolytic enzymes. It is thought to cause skin darkening by binding to the MC1 receptor which in turn drives melanogenesis. It has a short half-life of approximately 30 minutes. After administration with implantation into the skin, the majority of the drug is released within two days, with 90% released by the fifth day. By the tenth day, no drug is detectable in plasma. The details of drug distribution, metabolism and excretion remain unclear (as of 2026), but since it is a small peptide with a short half-life, it is expected that it is quickly broken down into shorter peptide fragments and amino acids.
Antibody diversification typically occurs through somatic hypermutation, class switching, and affinity maturation targeting the BCR gene loci, but on occasion more unconventional forms of diversification have been documented. For example, in the case of malaria caused by Plasmodium falciparum, some antibodies from those who had been infected demonstrated an insertion from chromosome 19 containing a 98-amino acid stretch from leukocyte-associated immunoglobulin-like receptor 1, LAIR1, in the elbow joint. This represents a form of interchromosomal transposition. LAIR1 normally binds collagen, but can recognize repetitive interspersed families of polypeptides (RIFIN) family members that are highly expressed on the surface of P. falciparum-infected red blood cells. In fact, these antibodies underwent affinity maturation that enhanced affinity for RIFIN but abolished affinity for collagen. These "LAIR1-containing" antibodies have been found in 5–10% of donors from Tanzania and Mali, though not in European donors. European donors did show 100–1000 nucleotide stretches inside the elbow joints as well, however. This particular phenomenon may be specific to malaria, as infection is known to induce genomic instability.
Sources: en.wikipedia.org
System suitability is a set of checks that confirm the instrument and method perform within limits before sample analysis. It typically includes resolution, tailing factor, retention time, and peak area reproducibility. If a check fails, the run is invalidated until the cause is resolved.
QC samples are usually injected at the beginning, at intervals during the run, and at the end. The exact frequency depends on the method, sample count, and regulatory requirements. Results outside acceptance limits can require rejection of the affected samples and investigation.
Method validation demonstrates that an HPLC procedure produces reliable results for its intended purpose. It provides documented evidence for accuracy, precision, specificity, and other performance characteristics. Regulators and quality systems require validation before a method is used for release or stability testing.
It measures the presence and amount of one or more compounds in a liquid sample. Separation occurs in a column, and detection produces a signal proportional to concentration. Identification usually requires comparison with a known reference standard under the same conditions.