retention time is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Updated 2025-08-13. Numbers and descriptions here follow the published literature rather than marketing material.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample by passing them through a packed column under pressure. A pump delivers a mobile phase at a controlled flow rate, and an injector introduces the sample into the stream. Differences in how analytes partition between the mobile phase and the stationary phase cause them to exit the column at different times. Detection then records a signal proportional to the amount of each separated substance. The resulting chromatogram provides retention times and peak areas for identification and quantification.
Instrumentation includes a solvent delivery system, an autosampler, a column oven, and one or more detectors. Reversed-phase columns with chemically modified silica are widely used, but normal-phase, ion-exchange, size-exclusion, and affinity modes exist for specific separations. Detectors may rely on ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry. Column temperature, mobile phase composition, and flow rate are adjusted to improve resolution. System pressure is monitored because rising pressure can indicate column blockage or deteriorating packing.
Several separation modes exist, including reversed-phase, normal-phase, ion-exchange, size-exclusion, and hydrophilic interaction liquid chromatography. Reversed-phase uses a nonpolar stationary phase with a polar mobile phase and is widely applied to small organic molecules. Gradient elution changes mobile phase composition during the run, while isocratic elution keeps it constant. Column chemistry, particle size, temperature, flow rate, and mobile phase pH all influence retention and resolution. Method development selects conditions that separate analytes from matrix components and from each other.
Detection commonly uses ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. Ultraviolet detection depends on molecular chromophores that absorb light at specific wavelengths. Mass spectrometry provides mass information and sensitive quantification, often after electrospray ionization. Before sample batches, performance checks examine resolution, elution time repeatability, peak symmetry, and plate count. Matrix effects and co-elution remain recognized uncertainties; formal validation studies and orthogonal detection help address them. Detector choice depends on analyte properties and required sensitivity.
| Property | Value | Notes |
|---|---|---|
| Separation principle | Differential partitioning | Analytes distribute between mobile and stationary phases. |
| Mobile phase | Liquid solvent mixture | Composition controls retention and selectivity. |
| Stationary phase | Packed column particles | Often chemically bonded silica. |
| Typical detector | UV-Vis or photodiode array | Mass spectrometry is also common. |
| Common synonym | High-performance liquid chromatography | Abbreviated as HPLC. |
High-performance liquid chromatography testing separates components of a liquid sample by forcing a mobile phase through a packed column. The stationary phase inside the column interacts with analytes to different degrees, so each compound exits at a characteristic retention time. A pump delivers solvent at controlled flow and pressure, while an injector introduces a precise sample volume. Detectors such as ultraviolet-visible, fluorescence, refractive index, or mass spectrometric instruments record the separated bands. The resulting chromatogram provides qualitative and quantitative information about the mixture.
Separation modes differ by the chemistry of the stationary phase and the composition of the mobile phase. Reversed-phase testing uses a nonpolar column and polar solvents, making it common for pharmaceutical, environmental, and food analytes. Normal-phase testing uses a polar column and nonpolar solvents for compounds that are poorly retained in reversed-phase systems. Ion-exchange and ion-pair methods separate charged species, while size-exclusion methods sort molecules by hydrodynamic volume. Gradient elution changes solvent strength over time to resolve complex mixtures, and isocratic elution holds solvent composition constant for simpler assays.
Key performance measures include retention time, peak area, peak height, resolution, tailing factor, and plate count. Retention time helps identify a peak under fixed conditions, but confirmation often requires a second method or detector. Peak area and height relate to concentration through calibration curves, which may be linear or nonlinear depending on the detector response. Resolution describes separation between adjacent peaks, while tailing factor and plate count describe peak shape and column efficiency. Performance checks verify these values before and during a run to confirm that the instrument is performing within limits.
Quality control laboratories use HPLC to check identity, purity, concentration, and stability of raw materials and finished products. A validated method specifies the column, mobile phase, flow rate, detection wavelength, injection volume, and run time. Samples are prepared and compared against reference standards of known concentration. The resulting chromatogram provides quantitative data, such as assay values and impurity levels. This approach is common in pharmaceutical, food, environmental, and industrial testing where consistent measurements are required.
Method validation demonstrates that an analytical procedure is suitable for its intended purpose. Typical validation characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulatory guidance from bodies such as the International Council for Harmonisation and the United States Pharmacopeia outlines expectations, though specific criteria depend on the product and method. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, column efficiency, and injection repeatability. Failure of these checks can invalidate a batch of measurements.
Practical HPLC testing depends on careful sample preparation and instrument maintenance. Samples may require filtration, dilution, pH adjustment, or extraction to avoid column damage and matrix interference. Mobile phases are degassed and filtered, and columns are equilibrated before injection. Common problems include peak tailing, baseline drift, ghost peaks, carryover, and co-elution of analytes. Documentation of instrument logs, calibration records, and electronic audit trails supports data integrity and traceability. Ongoing training and routine maintenance help reduce variability between analysts and laboratories.
Aerotolerant anaerobes use fermentation to produce ATP. They do not use oxygen, but they can protect themselves from reactive oxygen molecules. In contrast, obligate anaerobes can be harmed by reactive oxygen molecules. There are three categories of anaerobes. Where obligate aerobes require oxygen to grow, obligate anaerobes are damaged by oxygen, aerotolerant organisms cannot use oxygen but tolerate its presence, and facultative anaerobes use oxygen if it is present but can grow without it. Most aerotolerant anaerobes have superoxide dismutase and (non-catalase) peroxidase but do not have catalase. More specifically, they may use a NADH oxidase/NADH peroxidase (NOX/NPR) system or a glutathione peroxidase system. An example of an aerotolerant anaerobe is Cutibacterium acnes.
Bont possesses no superhuman abilities, but he occasionally used Mutant Growth Hormone, a substance that temporarily enhanced his speed and strength and caused his eyes to emit a green glow. Sigourney Weaver portrays a female version of Alexander Bont, primarily known as Alexandra, in The Defenders. This version is the leader of the Hand. Alexandra is described as an "adversary" rather than a villain and was intended to be portrayed sympathically as a supporting character in Elektra Natchios' story. Alexandra is one of the five "fingers" of the Hand, who all gained immortality using the healing powers of qi. Following the death of Elektra, Alexandra resurrects her to create the ancient weapon Black Sky, which is prophesied to destroy all enemies of the Hand. Alexandra intends to use Elektra to steal the Iron Fist from Danny Rand. However, Elektra regains her memories of her previous life and kills Alexandra, claiming leadership of the Hand. http://www.marvunapp.com/Appendix4/bontalexander.htm http://www.imdb.com/title/tt1784594/
Scleroderma, polymyositis, and dermatomyositis elicit little or no CRP response. CRP levels also tend to remain low despite inflammatory activity in systemic lupus erythematosus (SLE) unless serositis or synovitis is present. This may be explained by increased levels of type I IFN in SLE, since type I IFN (i.e IFN alpha) inhibits hepatic CRP production. A polymorphisms of the CRP gene which cause lower CRP levels is also more frequent in SLE patients compared with controls. Elevations of CRP in the absence of clinically significant inflammation can occur in kidney failure. CRP level is an independent risk factor for atherosclerotic disease. Patients with high CRP concentrations are more likely to develop stroke, myocardial infarction, and severe peripheral vascular disease. Elevated level of CRP can also be observed in inflammatory bowel disease (IBD), including Crohn's disease and ulcerative colitis. High levels of CRP has been associated to point mutation Cys130Arg in the APOE gene, coding for apolipoprotein E, establishing a link between lipid values and inflammatory markers modulation.
The American Society for Mass Spectrometry (ASMS) is a professional association based in the United States that supports the scientific field of mass spectrometry. As of 2018, the society had approximately 10,000 members primarily from the US, but also from around the world. The society holds a large annual meeting, typically in late May or early June as well as other topical conferences and workshops. The society publishes the Journal of the American Society for Mass Spectrometry.
Sources: en.wikipedia.org
15-Oxo-ETE). Other eicosanoid oxoreductases that use NAD+ and NADH as co-factors include: 12-hydroxyicosatetraenoate dehydrogenase which metabolizes 12-hydroxyeicosatetraenoic acid (12-HETE) and LTB4 to their corresponding 12-oxo analogs and 11-hydroxy-TXB2 dehydrogenase, which metabolizes TXB2 to its 11-oxo analog; and 15-hydroxyprostaglandin dehydrogenase (NAD+) which metabolizes (5Z,13E)-(15S)-11alpha,15-dihydroxy-9-oxoprost-13-enoate to its 15-oxo analog. Other eicosanoid oxireductases that use NADP+ and NADPH as cofactors include LTB4 12-hydroxy dehydrogenase which metabolizes LTB4 to its 12-oxo analog, and 15-hydroxyprostaglandin-D dehydrogenase (NADP+), 15-hydroxyprostaglandin-I dehydrogenase (NADP+), and 15-hydroxyprostaglandin dehydrogenase (NADP+) which metabolize PGD2, PGI2, and (13E)-(15S)-11alpha,15-dihydroxy-9-oxoprost-13-enoate, respectively, to their corresponding 15-oxo analogs.
Fatty change, or steatosis, is the accumulation of fatty acids in liver cells. This can be seen as fatty globules under the microscope. Alcoholism causes development of large fatty globules (macro-vesicular steatosis) throughout the liver and can begin to occur after a few days of heavy drinking. Alcohol is metabolized by alcohol dehydrogenase (ADH) into acetaldehyde, then further metabolized by aldehyde dehydrogenase (ALDH) into acetic acid, which is finally oxidized into carbon dioxide (CO2) and water (H2O). This process generates NADH, and increases the NADH/NAD+ ratio. A higher NADH concentration induces fatty acid synthesis while a decreased NAD level results in decreased fatty acid oxidation. Subsequently, the higher levels of fatty acids signal the liver cells to compound it to glycerol to form triglycerides. These triglycerides accumulate, resulting in fatty liver.
The American Society for Biochemistry and Molecular Biology publishes three research journals and a monthly magazine covering society news and activity updates. ASBMB journals are peer-reviewed and cover research in the fields of microbiology, molecular genetics, RNA-related research, proteomics, genomics, transcription, peptides, cell signaling, lipidomics, and systems biology. All articles are published online as "Papers in Press" upon acceptance. As of January 2021, all three ASBMB journals are fully open access.
Sources: en.wikipedia.org
This can be applied to find the best substrates for proteolytic enzymes. The substrate is displayed on the bacterial cell surface between an affinity ligand and the scaffold, and the kinetics of substrate proteolysis is measured using FACS. Bacterial display can be used to find peptides which bind to specific cells e.g. breast cancer cells or stem cells. Displayed proteins are fluorescently tagged with GFP, so binding interactions between peptides and target cells can be seen by flow cytometry. Control samples are required in order to measure fluorescence levels in the absence of displayed peptides. Samples are also required which don’t contain displayed peptides, but contain mammalian cells and bacterial cells (including the scaffold). Vaccine delivery is a very common application of bacterial surface display. There are two types of live bacterial vaccines that can be made:
Because lipopolysaccharides are potent inflammatory agents, and the action of antibiotics can result in the release of these compounds, the binding capacity of BPI was explored as a possible means of reducing injury. Xoma Ltd. developed a recombinant 21kDa portion of the BPI molecule called rBPI21, NEUPREX, or opebecan. In a trial, it was found to decrease the mortality of Gram-negative bacterial-induced sepsis. Studies suggest that its binding activity is not the means by which it mediates its protective effect. Studies show biological effects with Gram-positive bacteria and even in infection by the protozoan, Toxoplasma gondii. The N-terminal portion of murine BPI (199 amino acids) genetically fused to Halobacterium sp. NRC-1 GvpC protein was bound to the surface of gas vesicle nanoparticles (GVNPs) and tested for protective activity using a murine model of endotoxic shock. Depending on the time of delivery and exposure to lethal concentrations of lipopolysaccharide (LPS) and D-galactosamine, the treatment resulted in increased survival and reduced symptoms of inflammation, including inflammatory anemia, recruitment of neutrophils, liver apoptosis as well as increased pro-inflammatory serum cytokine levels. When administered via footpad and before LPS exposure, there was 100% survival of the experimental cohort.
The predecessor to the CAD, termed an evaporative electrical detector, was first described by Kaufman in 2002 at TSI Inc in US patent 6,568,245 and was based on the coupling of liquid chromatographic approaches to TSI's electrical aerosol measurement (EAM) technology. At around the same time Dixon and Peterson at California State University were investigating the coupling of liquid chromatography to an earlier version of TSI's EAM technology, which they called an aerosol charge detector. Subsequent collaboration between TSI and ESA Biosciences Inc. (now part of Thermo Fisher Scientific), led to the first commercial instrument, the Corona CAD, which received both the Pittsburgh Conference Silver Pittcon Editor's Award (2005) and R&D 100 award (2005). Continued research and engineering improvements in product design resulted in CADs with ever increasing capabilities. The newest iterations of the CAD are the Thermo Scientific Corona Veo Charged Aerosol Detector, Corona Veo RS Charged Aerosol Detector and Thermo Scientific Vanquish Charged Aerosol Detectors.
Sources: en.wikipedia.org
HPLC separates and detects individual compounds in a liquid sample, producing peaks at characteristic retention times. Peak area or height can be used to estimate concentration when calibrated with known standards. It does not identify unknown compounds with certainty unless additional detectors or reference materials are used.
Pressure drives the liquid mobile phase through a column packed with small particles. Without pressure, flow would be very slow or stop because the packed bed resists liquid movement. Modern pumps maintain a steady flow despite the resistance.
A chromatogram is a plot of detector signal against time after sample injection. Each peak represents a compound or group of compounds eluting from the column. Retention time and peak area are the main measurements read from the plot.
HPLC separates and quantifies compounds in a liquid sample. Detectors produce a response proportional to the amount of a compound passing through the flow cell. Identification by retention time requires comparison with a known standard.